This easy to apply Mixing Tip ensures an easy usage and adequately mixes the 2-components of an adhesive cartridge so it can perform and set at its optimum level. Apply the adhesive easily, effectively and waste free with the right adhesive dispensing equipment.
The here presented Mixing Tip fits perfectly to CowCare’s Sticky Dicky and Hoof-Tite HOT, Hoof-Tite COLD adhesives (or other similar glue cartridges) to ensure hoof trimmers with an easy application of glue.
The mixing tip system allows the user to fast change the Mixing Tip in seconds. Moreover, the size and the set-up of the Mixing Tip ensure cross-contamination, an easy and waste-free usage and time and money savings with an innovative, no-manual mixing system.
The here presented Mixing Tips are used for example with the Sticky Dicky and Hoof-Tite HOT, Hoof-Tite COLD adhesives, in a ratio of 8-10 mixing tips to 1 adhesive cartridge which includes the accessories for around 8-10 applications (depending on the size of the hoof and the operator’s skill).
Product features at a glance
- Easy to apply Mixing Tips
- Fit perfectly with CowCare offered glues
- Approx. use 8-10 tips to 1 cartridge
- Directly mixes 2-components of the glue
- Always the same mixing ratio, reduces waste
- Ideal for a proper and controlled application on rubber and wooden blocks
Instructions for use
First, place the 220ml cartridge into a 200/220ml Applicator Gun. Now, remove the fastener on the cartridge and connect the Mixing Tip. Equalize the cartridge by pointing the cartridge straight up; then squeeze the handle to remove any air bubbles.
Now, eject a small amount of glue. This must be done so that the two components mix as optimally as possible. Now, apply a bead of the glue onto a block. Place the block quickly onto the pre-prepared, clean and dry, healthy claw. A heat gun can be used to dry the claw.
After around 30 seconds, the glue will have set, and after around 2-3 minutes, the claw can weight-bear again. For the greatest result, the claw must be clean and dry. Leave the mixing tip in place until the next use. Replace with a new mixing tip before each new exercising.
A well-prepared claw contributes to a good and stable adhesion of the adhesive. The claw can also be roughened to increase the adhesive power. The used mixing tip may remain on the cartridge after use. The glue in the mixing tip cures and seals the cartridge. For the next application, a new mixing tip must be used. When pressing the block against the claw, do not work with too much pressure, as the adhesive layer will otherwise become too thin and no optimal adhesive bond can be created.
